N10 G21 G17 G90 (mm, XY plane, absolute) N20 G0 X0 Y0 Z5 N30 M3 S1500 (spindle on, clockwise, 1500 RPM) N40 G0 X10 Y10 N50 G43 H01 Z5 (apply tool offset) N60 G81 Z-10 R2 F300 (drill cycle: peck start at Z-10, retract to R=2, feed 300 mm/min) N70 X20 Y10 N80 X30 Y10 N90 G80 (cancel cycle) N100 G0 Z100 N110 M5 N120 M30

Tip: Always run a G0 dry run to verify coordinates and clearance before enabling the spindle.

For the machinist, this is the most valuable section. The Mini Wizard was designed to simplify math, but the interface is far from intuitive by modern standards. The manual covers the specific "conversational" programming language Anilam used.

Example simple G-code (illustrative):

G21 G90       ; mm, absolute
G0 Z10        ; safe height
G0 X0 Y0      ; rapid to start
M3 S12000     ; spindle on CW 12000 RPM
G1 Z-3 F200   ; plunge
G1 X20 Y0 F300; cut
G0 Z10
M5            ; spindle stop
M30           ; end

Let’s say you have searched for weeks and still cannot locate the original Anilam Mini Wizard A163 manual PDF. You have options: