Bradex - Bx60 Battery Charger Manual Full

Plug charger into mains socket – digital display lights up.

Select battery type using the MODE button (STD/AGM/GEL/RECON).

Press START – the charger runs a self‑test, then begins the 6‑stage charge:

“FULL” indicator appears – charging complete.

Unplug from mains before removing clamps.

The Bradex BX60 is an automatic battery charger designed for 12V lead-acid batteries (WET, MF, AGM, GEL) commonly used in cars, motorcycles, boats, and lawn tractors. It features microprocessor-controlled charging with a 6‑step charging process.

| Message | Meaning | |---------|---------| | 12.6V | Current battery voltage | | 6.0A | Charging current | | SUL | Sulfation detected – suggest RECON mode | | ERR | Reverse polarity or short circuit | | FULL | Charge complete | | HOT | Overheat protection – charger cooling down | bradex bx60 battery charger manual full

For advanced users only. Press and hold the "Mode" button for 5 seconds to enter Repair Mode. Use only on batteries below 8V that have been sitting for months. The charger will run a 6-hour desulfation cycle. Do not interrupt. Plug charger into mains socket – digital display

Allow the charger to complete its cycle; smaller chargers may take several hours to restore a depleted battery.

Once fully charged, switch off the charger and unplug from mains before removing clamps.

Remove the negative clamp first, then the positive clamp.

Re-check battery voltage with a multimeter; a healthy, fully charged 12 V lead-acid battery should measure about 12.6–12.8 V at rest.

Insert the AC plug into a grounded wall outlet. The charger will run a self-test (all LEDs flash briefly). “FULL” indicator appears – charging complete