Corghi Exact 60 Manual -

Corghi recommends a full load cell test and belt replacement every 5,000 cycles or yearly for busy shops.

| Symptom | Possible Cause (Manual Reference) | Corrective Action | | :--- | :--- | :--- | | Table won't rotate | Motor overload protector tripped | Reset button on motor housing. Wait 5 min. | | Bead breaker sticks | Low air pressure / Dirty slide rods | Check shop air (min 145 PSI). Lubricate rods with light oil. | | Rim clamp slips | Worn clamp jaws or low pneumatic pressure | Replace jaw inserts (Part # EX60-JAW). Adjust regulator to 160 PSI. | | Demount head scratches rim | Incorrect head height adjustment | Loosen lock bolt, adjust head to 2mm above rim flange. | corghi exact 60 manual

Unlike automatic machines, you must measure and enter three values: Corghi recommends a full load cell test and

Pro Tip from the Manual: If you enter an incorrect width, the machine will still spin, but the weight placement will be off by centimeters, resulting in a poor balance. Pro Tip from the Manual: If you enter

The Exact 60 requires three specific measurements to calculate balance. These are usually input using the number pad:

  • Width (B): Measure the width of the rim using the caliper provided with the machine.
  • Diameter (C): Identify the rim diameter size (e.g., 14 inches).

    • This is where most errors happen. You must measure the wheel and input the data before spinning.

  • Positioning: Rotate the wheel by hand slowly. The displays usually have position indicators (LEDs that rotate around a circle). When the LED is at the top (12 o'clock position), that is the spot for the weight.
  • Attachment: