Firmware 6.10 Download: Dap-1360

Vuoi che cerchi la pagina di supporto ufficiale D-Link per il DAP-1360 ora?

(Invoking related search suggestions.)

Important Note: D-Link has removed older firmware versions from many of its official regional support sites. Version 6.10 is not the latest firmware for most hardware revisions; however, if you specifically need this version for compatibility or legacy network reasons, follow the instructions below. Dap-1360 Firmware 6.10 Download

Downloading DAP‑1360 firmware 6.10 in 2026 is possible only via archived or community sources. Only pursue this if you need to fix a specific regression introduced in a later version (6.12+), or if your device is currently bricked and you need a recovery image. For general use, either stay on the latest v6.14 (if available for your region) or migrate to OpenWrt 23.05+ for security and modern features.

Always checksum‑verify any legacy firmware. D‑Link is not responsible for damage caused by third‑party downloads. Vuoi che cerchi la pagina di supporto ufficiale

If Firmware 6.10 fails to load or the device enters a boot loop, you must use the TFTP (Trivial File Transfer Protocol) recovery method. This is a low-level hardware interface that exists before the OS loads.

Step-by-Step TFTP Recovery:

Before downloading any firmware, you must know your device’s hardware revision. The DAP-1360 has multiple revisions (A, B, C, D, E, F, etc.). Firmware is not interchangeable between revisions.

Critical: Firmware 6.10 was primarily released for Rev C and some Rev D units. Do not flash this on Rev A, B, E, or F unless confirmed by D-Link’s release notes. Downloading DAP‑1360 firmware 6