An Epson 1390 Resetter (also known as a Waste Ink Pad Counter Reset Utility or Adjustment Program) is a piece of software designed to reset the internal counter inside your printer’s memory.
The Epson 1390 tracks how much ink has been used to clean the printhead. This waste ink flows into a sponge pad at the bottom of the machine. Epson programs the printer to stop working after approximately 15,000 to 20,000 page cleans, assuming the sponge is full.
However, in most cases, the sponge is not actually full. The counter is simply hitting a pre-programmed limit. The resetter tricks the printer into thinking the pad is brand new, allowing you to continue printing.
| Pros | Cons | |------|------| | Saves money on service center fees | Does not physically replace ink pads | | Extends printer life significantly | May void warranty (if still under warranty) | | Quick (takes 2 minutes) | Requires basic PC skills | | Works offline | Some versions trigger antivirus false positives | epson 1390 resetter
If you cannot find the Epson 1390 Adjustment Program, you can use WICReset. This is a commercial universal resetter.
The Epson Stylus Photo 1390 is a high-performance A3+ photo printer beloved by photographers and designers. However, like all inkjet printers, it has a built-in waste ink pad counter. Once this counter reaches its limit, the printer stops working and displays a “Service Required” error (usually blinking lights or a message like “Parts inside your printer are at the end of their service life”). The Epson 1390 Resetter is a software tool that resets this counter, giving your printer a second life without an expensive trip to a service center.
This is a grey area. Legally, the Digital Millennium Copyright Act (DMCA) in the US allows circumvention of software locks for the purpose of maintenance and repair (as of 2021 exemptions). Epson would prefer you send the printer to a service center. However, for a printer as old as the 1390 (discontinued in most markets), using a resetter is universally accepted by the DIY printing community. An Epson 1390 Resetter (also known as a
If you own an Epson Stylus Photo 1390 (or its close relative, the Epson Photo R1390), you are likely aware of one of its most frustrating design flaws: the Waste Ink Pad Counter. After years of reliable photo printing, your printer suddenly stops working. The red lights flash, a message pops up on your PC, and the screen reads: “Parts inside your printer are at the end of their service life.”
Before you throw a perfectly good photo printer into the trash, you need to meet your new best friend: the Epson 1390 Resetter.
In this article, we will explain what a resetter is, why you need it, how to use it safely, and where to find reliable software. Epson programs the printer to stop working after
The "Resetter" is a piece of software officially known as the Epson Adjustment Program. It is distinct from standard printer drivers. While drivers tell the printer what to print, the Adjustment Program tells the printer how to maintain itself.
Its primary function for most users is to reset the Waste Ink Pad Counter. Epson printers are designed to stop working after a certain number of cleaning cycles to prevent ink from overflowing the internal pads and leaking onto your desk. The resetter tells the printer's logic board that the pads are "new" and resets the counter to zero, allowing you to print again.