If you need >40A output, you can connect two BP 10140 units in parallel. The manual specifies:
The Hager BP 10140 is a top-mounted accessory designed for use with Hager enclosure systems (e.g., distribution boards, control panels). It provides cable entry, gland mounting, or ventilation openings at the top of the enclosure while maintaining IP protection.
Key features:
Do not rely on third-party image hosts. Go to the source:
For critical loads (e.g., PLCs in a chemical plant), use a redundancy module (e.g., Hager RMD-1) with two BP 10140s. If one fails, the other takes over seamlessly. The manual provides a topology diagram on page 4 ("Top-level system integration"). hager controls bp 10140 manual top
| Problem | Remedy | |--------------------------------|--------------------------------------| | Cover does not sit flush | Check gasket alignment / debris | | Screws won’t engage | Verify correct enclosure model | | IP rating not achieved | Replace damaged gasket |
Based on real-world feedback from panel builders: If you need >40A output, you can connect
| Problem | Likely Cause (from manual) | Solution | | :--- | :--- | :--- | | Overheating at top clamp | Screw not torqued to spec. | Re-torque to 3.0 Nm. Check for busbar burrs. | | Phase rotation error | Adapter installed backwards (TOP arrow facing load). | Remove, flip adapter, re-install. | | Loose fit on busbar | Wrong busbar thickness (using 5mm bar instead of 10mm). | Replace busbar or use busbar shim kit (Hager BS10). |