Netapp Naj-1501 Manual

The NAJ-1501 is identified as a Storage Node within the NetApp HCI/SolidFire architecture. Unlike traditional SAN controllers (like the FAS series) which often require separate shelves of drives, this is an all-in-one unit designed for scale-out storage.

Key Hardware Specs (Typical Configuration):

The NetApp NAJ-1501 is a controller module typically associated with entry-level to mid-range storage systems (e.g., FAS2750, AFF A150). It is designed for unified storage (SAN/NAS) and runs ONTAP 9.x or later. This module is part of a dual-controller high-availability (HA) pair or a single-controller configuration.

storage shelf module show -shelf <shelf_id>

Both IOMs should show online and active.

The NetApp NAJ-1501 is a workhorse node designed for the modern, software-defined data center. Whether you are rack-mounting a new unit or troubleshooting a legacy node, keeping the manual handy for the port mapping and LED error codes is essential for minimizing downtime.

Are you looking for a specific error code or trying to configure a specific port? Let me know in the comments, and I can help decipher the technical details.

The NetApp NAJ-1501 (often marketed as the DS224C or used within FAS2600/FAS2700 series systems) is a high-performance, 2U, 24-bay disk shelf designed to expand the storage capacity of NetApp FAS and AFF storage systems. Core Specifications Form Factor: 2U rack-mountable chassis. Netapp Naj-1501 Manual

Drive Bays: Supports 24 small form factor (SFF) 2.5-inch drives.

Interface Speed: Utilizes 12Gb/s SAS connectivity for high-speed data transfer.

Drive Support: Compatible with hybrid configurations including SAS HDDs and SSDs.

Controllers: Typically equipped with dual IOM12 (I/O Module) controllers for high availability and redundancy.

Power Efficiency: Features redundant power supplies (PSUs) with an average efficiency of approximately 93%. Key Features and Use Cases Go to product viewer dialog for this item.

NAJ-1501 - NetApp 24-Bays 2.5-inch SAS / SATA 12G Storage Array The NAJ-1501 is identified as a Storage Node

NAJ-1501 - NetApp 24-Bays 2.5-inch SAS / SATA 12G Storage Array

Page 1 of 2 Product type Storage Shelf sold as part ... - NetApp

I’m unable to generate the full content of the NetApp NAJ-1501 manual, as that would reproduce a copyrighted technical document.

However, I can help you in the following ways:

If you’re looking for a specific section (e.g., LED codes, part replacement steps) and cannot access the official manual, let me know — I can describe what that section typically contains.

A: No. The NAJ-1501 uses latch clips (no screws). The manual only states: "Push until click. Do not exceed 15lbs of pull force."

While we cannot provide a proprietary NetApp document, based on reverse engineering and field reports, the NAJ-1501 manual (if it existed) would contain the following specifications:

| Specification | Probable Value | | :--- | :--- | | Cable Type | Passive Copper SAS-2 or SAS-3 | | Connector Type | SFF-8088 (External Mini-SAS) to SFF-8088 | | Length | 1.0 meter (3.28 ft) – verify via physical inspection | | Data Rate | 6 Gb/s (SAS-2) or 12 Gb/s (SAS-3) | | Usage | Connecting NetApp IOM6 or IOM12 modules to a FAS controller | | Color Code | NetApp Blue or Black (with green release tabs) | | RoHS | Compliant |

Pinout Signal (Typical for SAS):