| Error Code | Description | Possible Cause |
|------------|-------------|----------------|
| E1201 | Door open timeout | Defective door operator or obstruction |
| E2105 | Drive overcurrent | Inverter issue, motor short, or mechanical jam |
| E3102 | Safety chain open | Emergency stop, gate lock, or overspeed governor |
| E4103 | CAN bus communication error | Loose wiring between car and controller |
| E5110 | Position reference lost | Faulty encoder or tape reader |
| E6001 | Brake pickup fault | Brake coil or contactor failure |
Note: Always refer to the official Schindler 5500 Fault Code List for your specific firmware revision.
Severity: Critical | Likely Result: Safety gear activation, rescue required. schindler 5500 error codes top
What it means: The car’s actual speed exceeded the commanded speed or the safety governor threshold by more than 15%. This is rare but terrifying.
Common Causes:
Troubleshooting: Immediately check the governor rope tension and sheave groove wear. Verify encoder wiring shielding (EMI interference is common).
Status: Traffic Management, Not a True Fault | Error Code | Description | Possible Cause
Description: In a Schindler 5500 group of 2–8 cars, this code indicates that the group dispatcher has assigned all calls, and a specific car is waiting for a landing call that has been taken by another car. Often misinterpreted as a jam.
Common Causes:
Troubleshooting Steps: