Unraid Reset Network Settings Install May 2026

If DHCP is broken on your router:

ip addr add 192.168.1.50/24 dev eth0
ip link set eth0 up
ip route add default via 192.168.1.1

Then access the WebGUI at 192.168.1.50 and set a permanent static IP via Settings > Network Settings.

If no backup exists, create a minimal working network.cfg for DHCP (example):

IFNAME[0]="eth0"
MAC[0]="00:11:22:33:44:55"   # replace with your NIC MAC (optional)
NM_CONTROLLED="no"
USE_DHCP="yes"
IPADDR="0.0.0.0"
GATEWAY="0.0.0.0"
DNS_SERVER="0.0.0.0"

Save as /config/network.cfg.

Reboot the server.

Verify network in the GUI or via console (ip addr, ip route, ping).

This is the most common method when searching for "reset network settings install" — you cannot even get to the console. unraid reset network settings install

Step-by-Step:

Optional but Recommended: Delete wireless.cfg if you ever used Wi-Fi.

Safely eject the USB drive.

Re-insert the USB into your Unraid server and power on.

After booting, Unraid will act like a fresh install regarding networking — it will request an IP from your router via DHCP. Check your router’s DHCP lease table for the new IP address. The server name will remain unchanged. If DHCP is broken on your router: ip addr add 192

This guide covers how to reset Unraid network settings, restore defaults, and reinstall or reconfigure network adapters. Follow the steps that match your situation: simple settings reset, hardware/driver reinstall, or full network reconfiguration after a corrupted config.

Warning: modifying network settings can temporarily disconnect management access. If you’re remote, ensure console or physical access. Then access the WebGUI at 192

Try these next steps:

Follow these steps to reset Unraid network settings and perform a clean reinstall while preserving your array data where possible. Assumes Unraid 6.x and a USB-flash-key boot device.

If you want a completely blank slate: