Write At Command Station V104 Download Top 〈Windows〉

Use the appropriate flasher tool:

Wait for the process to finish; do not disconnect power.

Reboot device and open a serial terminal (baud rate typically 115200, 8N1) to watch boot messages.

If device requires configuration, restore or reapply saved settings.

Connect your station via serial. Open your terminal at 115200 baud (default for V104). Send the following sequence to unlock writing:

ATE1                  (Echo on)
AT+CMEE=2             (Verbose errors)
AT+WRITE=0,"V104_top" (Optional: label the firmware slot)
AT+UPGRADE

Then transfer the firmware using XMODEM or YMODEM (the exact protocol is specified in your station’s V104 release notes). Use: write at command station v104 download top

AT+WRITEFW=<length>

After transferring, issue AT+WRITE=1,ACTIVATE to write the new image to the active partition. Use the appropriate flasher tool:

Warning: Before proceeding, back up your current configuration using AT+READ or vendor backup tool. An incorrect write command can brick the station. Wait for the process to finish; do not disconnect power