Arduino Sensor Shield V5 0 Manual -

The beauty of the v5.0 is that you rarely need a breadboard anymore.

1. Connecting an HC-SR04 Ultrasonic Sensor (Distance)

2. Connecting a Servo Motor

3. Connecting an Analog Joystick

⚠️ Warning: Do not power more than one or two small servos from the Arduino’s 5V regulator. Use external power for anything larger. arduino sensor shield v5 0 manual

int motionPin = 7; // Signal wire goes to D7
void setup() 
Serial.begin(9600);
pinMode(motionPin, INPUT);

void loop() 
int motionState = digitalRead(motionPin);
if (motionState == HIGH) 
Serial.println("Motion Detected!");
delay(100);
 The beauty of the v5

This is the most common point of failure for beginners. Look near the Servo headers for a small 2-pin or 3-pin jumper (sometimes a sliding switch). void loop() int motionState = digitalRead(motionPin)

Located along the edges of the board, the Digital I/O section provides access to pins D0 through D13. Each pin is broken out into a 3-pin GVS header.