Bosch Kl 1208 User 39-s Manual ✰
A: The Bosch KL 1208 was sold worldwide. Look for the "Multilingual" section at the back of the PDF. English typically starts after the German, French, and Italian sections. The page numbers will restart with "E-1."
The safety section is thorough without being overly alarmist. It covers hydraulic pressure risks, pinch points, and electrical safety when working near live circuits. The bolded warning boxes are impossible to miss, ensuring that even a user skimming the manual will see critical safety data.
Since Bosch no longer ships this manual with new tools, you must rely on digital archives. Here are the most reliable sources:
The Bosch KL 1208 uses a two-wrench system for bit changes. The manual shows exactly how to:
Common Mistake: Users often overtighten the collet. The manual specifies "hand-tight plus 1/4 turn with wrench." Overtightening can crack the collet.
This diagram labels every part. Pay special attention to: Bosch Kl 1208 User 39-s Manual
If you want, I can:
The Bosch KL 1208 (or ML 1208 E) is a battery charger designed for all 12 V batteries (standard motor vehicle starter, boat, lawn mowers, etc.) with a capacity of no less than 5 Ah. Key Operating Instructions Preparation:
Unscrew all screw-plugs on standard batteries before charging.
Check fluid levels; lead plates must be covered by approximately 5 mm of fluid. Top up with distilled water if necessary.
Ensure the charger is in a dry environment and not on a heated base. Connecting the Charger: Verify the charger voltage matches the battery (12 V). A: The Bosch KL 1208 was sold worldwide
Connect the red clip (+) to the positive terminal and the black clip (-) to the negative terminal.
Plug the charger into the wall outlet and set the device switch to the "I" (On) symbol. The middle red LED must light up to indicate operation. Battery Testing:
The unit can test 12V batteries (24–66 Ah capacity) without being plugged into mains power.
Set the switch to "TEST" and load the battery (e.g., by turning on a vehicle's high beams for ~30 seconds). Indicator Meanings: Continuous Yellow LED: Charging not necessary. Flashing Yellow LED: Charging is required. No Light: Battery charge is critically low. Disconnection:
Always turn off and unplug the charger from the power supply before removing the clips from the battery to prevent sparks. Safety Warnings Common Mistake: Users often overtighten the collet
Explosive Gases: Charging produces explosive gases. Always ensure adequate ventilation and keep away from sparks or flames.
Corrosive Acid: Battery acid is highly corrosive. Rinse skin or clothing splashes immediately with soap and water.
Temperature: Do not use the charger in ambient temperatures exceeding 35°C.
For further details or official documentation, you can search for the model on the Bosch Automotive Service Solutions media library or the Bosch Classic Archive. Historic workshop equipment | Bosch Classic
The manual scores high marks for its logical flow. It follows the standard technical documentation hierarchy: Safety, Technical Specifications, Operation, Maintenance, and Troubleshooting.