Oneaccess+one100+installation+manual+oneaccess+work

To serve local clients, configure a LAN interface with DHCP.

Step A: Mounting

Step B: Connections

interface eth1
 description WAN-Static
 ip address 203.0.113.10 255.255.255.248
 no shutdown
ip route 0.0.0.0 0.0.0.0 203.0.113.1

Verify WAN operation:

ping 8.8.8.8
ping google.com

If both succeed, your OneAccess ONE100 is working online.

If your One100 has the optional LTE module: oneaccess+one100+installation+manual+oneaccess+work

configure terminal
interface cellular 0/0
 apn your.provider.apn
 pin 0000   (if required)
 no shutdown

Wait 30–60 seconds for LTE registration. Use show cellular 0/0 status to confirm signal and IP assignment.

Common failure: The LTE modem won’t initialise without a valid APN. If you see Modem: Down in status, the APN is likely missing or incorrect.

To force ZTP mode:

Upon first login, you may be forced to change the password. Follow the prompts.

OneAccess One100 Installation Manual

Introduction

Congratulations on purchasing the OneAccess One100, a state-of-the-art access control system designed to provide secure and efficient management of access to your premises. This installation manual will guide you through the process of installing and configuring the OneAccess One100 system.

System Components

The OneAccess One100 system consists of the following components:

Pre-Installation Checklist

Before proceeding with the installation, ensure that: To serve local clients, configure a LAN interface with DHCP

Installation Steps

The One100 supports ZTP (Zero-Touch Provisioning). The manual’s ZTP section is technically correct but misses real-world nuance.

To make ZTP work:

Why ZTP fails often:

Workaround: Manually load a bootstrap config via USB stick (format FAT32, file named bootstrap.cfg). This method is not in the basic manual but works universally. Step B: Connections