Spypiss Pro Hot -

To get accurate results, follow this professional protocol:

Step 1: Pre-Scan Setup Ensure the pipe system is running at full operational temperature and pressure. The "Hot" mode requires a minimum delta of 10°C between the fluid and the ambient ground. Action: Press the Thermal Boost button for 3 seconds to calibrate to ambient.

Step 2: The Contact Method Place the acoustic ground microphone on the suspected area. Use the included gel coupling pad. Action: Toggle to Mode 4 (Ultrasonic Hot Water). Listen for a "frying" sound through the Bluetooth headset. spypiss pro hot

Step 3: The Non-Contact Sweep Hold the camera 12 inches from the floor. Activate Grid View. The device will overlay a red-to-blue gradient. A true active hot leak appears as a "comet tail"—hot at the source, fading to cold. Warning: False positives occur near floor drains or electrical conduit. Cross-reference with the acoustic data.

Step 4: Verification Inject a thermal contrast agent (sold separately as "Spypiss Trace-Hot") into the line. Run the scan again. The agent fluoresces under the Pro Hot’s IR filter, confirming the leak location before breaking concrete. To get accurate results, follow this professional protocol:

Because this device handles extreme temperatures (from -20°C storage to 150°C probe peaks), care is critical.

Even a pro can struggle if the environment is hostile. Here are solutions to frequent issues: Problem: "The acoustic mode picks up traffic noise